Master Fin screw cutter...I am, I am...

[Quetzalcoatl]

I NOW consider myself a "Master Fin screw cutter!" This is in part that since the wind has been sooo low..(non existent) and

I've had plenty of time to outfit many of my fins with correct fitting screws (stain-less steel that is!).

So, with practice I've really put out some amazing screws.

I always keep a dozen or so (100 cm. long) stainless steel screws around,,and then I cut them down to size.

There are several "techniques" that need to be applied in order to "get it right!" If not,,then you get it wrong and waist a perfectly good screw.

Although I do now call myself a "Master Fin Screw Cutter", I'd really rather have a chance to practice windsurfing (need wind) so I could become a "master windsurfer."

Quetzalcoatl (the "Master Fin Screw Cutter") out.